Qizige Atomizer Build Data and Flavor Data Sharing

  What wire data and flavor are good for the Go board?

  Answer: The Go atomizer is a flavor-type atomizer suitable for mouth-to-lung (MTL) vaping. For making the heating coil, I recommend a slightly higher resistance (1.0-1.8 ohms) and using a slightly finer heating wire, such as 0.32mm (28g) or 0.25mm (30g).
  Wire diameter: 0.32mm (28g), coil diameter 2.5mm, number of coils: 6-8. Resistance: 1.0-1.4 ohms.
  Using 0.32mm (28g) heating wire, the vapor production and flavor are quite balanced.
  Flavor: The 0.32mm (28g) heating wire creates a rich flavor with moderate vapor production, which is very helpful for beginners transitioning from smoking. The narrow airflow and condensed chimney help the vapor to coalesce, resulting in a balanced vapor and flavor, excelling in simplicity of construction.
  Vapor: The vapor is quite balanced and not overly pronounced, making it suitable for daily replacement of cigarettes.
  Using 0.25mm (30g) heating wire yields a slightly richer effect compared to 28g wire, or it can be said to be closer to a liquid state.
  Flavor: The 0.25mm (30g) heating wire creates a flavor closer to a liquid state, with a lower vapor conversion rate. The oil's resolution is quite good.
  Vapor: Since the vapor is close to a liquid state, the vapor production is not large, but it is rich in flavor.
  If you want a higher oil concentration with the Go atomizer, choose 0.25mm (30g), but the construction difficulty is slightly higher, and the vapor production may not be impressive. If you prefer larger vapor, then choose 28g heating wire.
      For a review of the Go atomizer, you can click on the article below to learn more:
       How is the Go Atomizer?