User Case: Successfully Fixed the Red Light Issue
A user shares a successful red light repair case, explaining how they carefully pushed the inner assembly out from the bottom with a screwdriver to access the internal shell and components.
A lot of people can’t figure out how to open the holder, so I studied it myself and finally managed to open it without damaging it. It’s actually quite simple. First, prepare a Phillips screwdriver, then put a small ball of cotton on the tip. Push upward from the bottom of the holder. While pushing, hold the holder with one hand, and tap the end of the screwdriver little by little so it gradually moves upward. After the outer shell comes off, the inside is exposed, and there is still a black inner shell. Then use two disposable chopsticks to brace the end where the tobacco stick is inserted and gently push it, and the innermost layer will come out. Then you’ll see a lot of tar. Only after taking it apart did I realize there is actually an oil drainage channel inside the holder. After cleaning it thoroughly, reassemble it, and ok, it works normally again
---------------------
Editor’s warning: Do not try this unless you are skilled with hands-on work! You may damage it, and replacement parts are not available!
---------------------
Editor’s warning: Do not try this unless you are skilled with hands-on work! You may damage it, and replacement parts are not available!
