The Real Cause of Spitback in High-Vapor Vape Atomizers

There may be a vapor who has experienced this situation:He took out his e-cigarette excitedly and prepared to take a puff, but was scalded by small droplets of boiling smoke oil.Especially for novices,thisOil frying phenomenon in atomizerHappens often.

The reasons for frying oil are complex, but most of them are problems with our players.I sorted out several questions about frying oil and hope to help everyone.

?

?

?

?1?

What is atomizer frying oil?

?

The e-cigarette atomizer turns the smoke oil into water mist through coil heating.

?

However, when the coil heats up rapidly, the smoke oil often does not turn into water mist due to various reasons, but directly shoots out of the coil and even enters our mouths.

?

#p#Pagination Title #e#This is what everyone often calls the phenomenon of frying oil in an atomizer.

?

.

.

?2?

Cotton is the biggest factor causing frying oil

?

Some players think that when wearing cotton, it is enough to fill the coils. Wearing too much will cause the coils to deform and reduce the strength of flavor restoration.

?

But cotton will shrink after wetting, and it mayCan't fillCoil. Excessive tobacco oil will flow out along the cotton and accumulate inThe gap between cotton and heating coilBetween,at elevated temperaturesExplode it in liquid form.

?

Solution: Wear more cotton,Fill the gaps in heating coils and cotton. (But don't wear cotton too tightly!)

?# p#pagination title #e#

?

?

?3?

Output power of the hostand one of the culprits.

?

Excessive power is more common in oil-dripping atomizers. Oil dripping atomizers generally open the lid to add oil, so an oil film will inevitably appear on the surface of the heating wire. When the temperature increases instantly, the oil film will burst.

?

Too low power is more common in oil storage atomizers. Too low power causes the heating speed to slow down, and the smoke oil accumulates and cannot be atomized sufficiently and quickly, resulting in the phenomenon of frying oil.

Solution: Adjust the equipment to find the right power. Of course, you can also directly purchase a voltage regulator host that does not require adjustment.

?

?

? 4

Unreasonable matching of shredded flowers will also lead to frying oil

For example, when the popular Clapton coils are used, the heating of the main and auxiliary wires will not match because the resistance values of some coils are not matched.# p#pagination title #e#

?

Solution:1Pay attention to purchasing fancy coils with good resistance values, and also pay attention to the output power of the host and the quality of cotton production.

?

?

?

?5?

Player usage habits

?

Some players dare not breathe in big breaths when using a relatively large smoke atomizer for the first time. As a result, the tobacco oil burned in the air and there was no cold air to mix with it. Finally, the tobacco oil piled up in chaos and fried oil occurred.

?

Solution: After almost debugging, I sucked boldly. This is not dangerous goods.There is no need to be afraid.

?

?

?6

Why is the finished core fried in oil?

?# p#pagination title #e#

This phenomenon mostly occurs when the atomizer is still for too long. When the atomizer is still for half a day or more, it is easy to fry oil, which is caused by the physical characteristics of cotton to conduct and store oil.

?

Solution:1After the atomizer is still for a long time, do not use the first and second ports directly. First,"ignite normally" the atomizer twice to allow the excess smoke oil to be atomized first.

The following are common parallel problems with finished atomizing core frying oil:

?

[Power] Improper use of power can lead to frying oil. For example, if the power is too low, the heating speed of the coil is too slow, the coil will fry the cigarettes before reaching the atomization temperature;

?

[Smoke oil] The VG content of the tobacco oil should comply with the oil conduction setting of the core. Some finished cores have extremely fast oil transfer speeds. At this time, using tobacco oil with too low VG (50%) will lead to excessive oil transfer;

?

[Runxin] Most friends will be interestedNewly used finished coreCarry out moisturizing,During this process, if too much tobacco oil is injected, frying oil will also occur.

?# p#pagination title #e#

?

These are several important factors that lead to the frying of oil in the atomizer