RELX 1st Generation Flashing Red Light 3 Times: Causes and Fixes for No Vapor

RELX 1st Generation is the first product launched by RELX and has made a deep impression on users. As a preferred entry-level vaping product, RELX 1st Generation has withstood the test of the market and remains a best-seller in many stores today.

In addition to the reliable product quality, its simple and practical design, affordable price, and variety of flavors are reasons why users love this product.

However, some users still have questions about the functionality of this product during use. For example, why does the RELX 1st Generation indicator light flash red three times? Why does it not produce vapor after the RELX 1st Generation pod is installed?

Below, I will introduce the reasons behind these issues.

1. Reasons for the RELX 1st Generation Indicator Light Flashing Three Times:

1. Over-inhalation Protection: If a puff is taken for more than 5 seconds, a protective mechanism activates to prevent the user from choking. (Try taking smaller, slower puffs.)

2. Overcharge Protection: If the charging cable is pulled out too forcefully or plugged in and out carelessly when charging ends, the device's indicator light will flash three times as a self-protection mechanism.

Note: If the device does not light up while charging, it is recommended to check if it can be used normally. If it can, the battery may still be fully charged, causing the charging indicator light not to illuminate.

2. Reasons for RELX 1st Generation Not Producing Vapor:

If your device has not been dropped or damaged, and you experience a "no vapor" issue, you can try the following methods to troubleshoot:

1) You can use a cotton swab or tissue to wipe the contact point at the top of the device and the water droplets at the bottom of the pod.

2) Try using a different pod to see if it works normally.

3) Gently tap the bottom of the device and pod on a flat surface to disperse any condensation.

4) Press the four small copper points at the bottom of the pod, insert it into the device, and gently move it while trying to use it.

5) Check how much e-liquid is left; if the e-liquid is too low, it may cause uneven heating and result in no vapor.

6) If you are using it for the first time, remember to remove the transparent plug at the bottom of the pod. (The transparent plug is located in the middle of the bottom of the pod and must be removed for vaporization.)

These are the reasons and solutions for the RELX 1st Generation indicator light flashing and not producing vapor. Did you learn something from this?