Want Big Clouds? Learn to DIY Fancy Coils in 3 Minutes

? Q:? What is the one thing you want to do most after owning an e-cigarette?

?

want to playgreat smog？

wantfancy smoke ring？

want to have your ownFancy electronic cigarette heating wire？

/

Today, the intimate editor will bring you

? Three-minute crash course?

teach you howDIY fancy heating wire #p#pagination title #e#

?

? How to DIY fancy heating wire??

? ?When we make and buy a fancy silk, how should we fire it???

Note:Never burn it violently or use ultra-high voltage,In the light case, it will damage the auxiliary yarn of the fancy yarn, and in the serious case, it will cause all the heating yarn to be scrapped.

?# p#pagination title #e#

?

?Step 1：? Prepare a fancy silk?

?

?Step 2：? Cleaning fancy silk?

(Use a toothbrush dipped in hand sanitizer or baking soda to soak and clean)

?

?Step 3：? Put the cleaned fancy silk on the atomizer?

Tips：Double-hair fancy silk should try to ensure the same length of stitching on both sides #p#Page title #e#

?

?

?Step 4：? Adjust voltage?

Adjust the voltage to around 3.5V

?Step 5：? Start burning silk?

Press the ignition button for 0.5 seconds to 1 second, using the ignition method (1 second interval, keep igniting)

Tips：At this time, a short circuit will appear in part of the heating wire. The most direct evidence of a short circuit is that an excessively bright bright spot will appear in a small piece of the heating wire. When a bright spot appears, remember the approximate location of the bright spot and enter the sixth step.

?

#p#Pagination Title #e#?Step 6：? Scrape and polish the parts?

Take polished ceramic tweezers and gently scrape the bright spots. After scraping, try igniting again. Pay attention to the internal and external highlights of the heating wire

Tips：The internal and external highlights are treated in the same way. For the internal highlights, just stick ceramic tweezers in and scratch them.

?

?

?Step 7：?Increase voltage?

When there are no bright spots, increase the voltage to 3.8V

If both coils areeven heating

Congratulations to #p#pagination title #e#

? Have you successfully got fancy heating wire?

?

If it appears at this timeOne side heats up quickly, the other side heats up slowly

Then you may want to check whether the homemade heating wire isThe following problems occurred:

?1. ?The screws on the moldings are not fixed

?2.??The auxiliary wire on the surface of the heating wire is blackened or burned

?3.??# p#pagination title #e#Touch between heating wire and electrode column

?4. ?The heating wire leg is too long or the length difference is too large

?5. ?Inconsistent number of heating coils

?

Finally, remember to check whether the atomizer electrode column is loose

(Shake the electrode column with your fingers. If the electrode column is loose, re-tighten the positive screw at the bottom of the atomizer)

? Have your own fancy heating wire?

? Unlock more new ways to play now?